Third Party Press

zeroing in the zf41 scope

idim002

Junior Member
Hello,
was just wondering if anyone has detailed pictures with instructions on how to zero in the zf41 scope please?
Is this video 100% correct?
https://www.youtube.com/watch?v=rLMU1wQdNJo
In the Senich Book page 199, they seem to suggest removing the that the objective cell retaining ring is completely unscrewed and removed for zeroing whereas the guy above suggest only unscrewing it a 1/4 turn..
Thanks so much
 
Unscrew front piece with little circle wrench.
Unscrew little screw enough to move shield.
Turn the shield to allow view of turrets.

I also purchased a little thing that goes into barrel and has a squared chart like graphing paper inside, every line was some inches. Think it was called collimeter.

I was hitting with it on 400 at 100 yards 1.5 inch high, I used chart, noticed where crosshair was on 400, dialed to 100 readjusted dials, locked everything down.

Could also adjust the elevation screw on mount.
 

Military Rifle Journal
Back
Top