Fal Grunt

You’d need to post pictures, the Turks “standardized” their rifles, but still made several variants while standardizing them. It’s not...

We have had several folks asking for these, and it seems like while there used to be several makers, those have dried up. Made from the...

Fantastic, Thank you for sharing! A couple of things to note. The rifle discussed in the first document is not a Gewehr 98, but more...

Send me a message with your email when you get a chance, I can't remember if I have it or not. There's a couple minor issues with this...

My apologies for the delay in posting these. We traveled for the eclipse and our location had limited connectivity. Jon sent the...

No worries, I do it for a living and still do it myself. Happens more than you would think, even with modern drawings. I typically try...

Are you measure the 10,0 dimension from the radius to the tip of the extractor claw? This is a tough dimension to measure, and did vary...

Bruce I’ll have to check my book when I get home, but if you print another batch, I’ll take one. Thanks!

Very cool! Thanks for sharing. More on Mauser’s patent battles can be seen in Speeds Archive book. I’ve done some looking around...

There are a couple of options, but it would be best that you pull the barreled receiver from the stock. First instinct would be to say...

I would be interested to see more pictures too!

His name even says roughneck, you guys are lucky he didn't use an 60" pipe wrench to remove it! We all come from different...

I'm going to be the voice of dissent and say that it is simply a commercially proofed straight handled bolt. Without other markings to...

My rifle is a 219, and the bolt face looks identical to those shown above. Bolt handle, bolt plug (good use of original nomenclature...

I know the survey isn't set up specifically for the MS series, but it's be great if you filled it out as best you could for those four...