I am about ready to replace a rear sight sleeve due to the fact that Bubba ground-off the upper handguard retainer lip on the existing one.
I plan to use a Bernzomatic propane torch to heat the sleeve.
When I install the new one, do I need to add solder, or will the residual solder around the barrel be sufficient. Also, can I use regular electrical solder, or do I need something more exotic?
All comments are welcome, thanks!
I plan to use a Bernzomatic propane torch to heat the sleeve.
When I install the new one, do I need to add solder, or will the residual solder around the barrel be sufficient. Also, can I use regular electrical solder, or do I need something more exotic?
All comments are welcome, thanks!