Third Party Press

P38 Rear sight issue

Herk1994

Senior Member
So I’ve posted this Spreeworke cvq stamp example on here before, I’m at a point where I want to address the rear sight issue I have. All assembled it rests high on the right side. The sight itself seems to be bent down the middle. Any input? Is the spring correct I wonder or lifting it too high? Detailed pictures posted.

image.jpg
image.jpg
6120E2B8-7894-4377-9C5B-CE5F021F2F8A.jpg

Thanks in advance

Brandon
 
rear sight

Yup it sure looks bent, simple solution is to replace it. Its not a numbered part. Regards Dave
 
I would gently straighten that sight....turn it base up on a firm/steel surface and carefully tap the center with a small non-marring hammer/punch.


Sent from my iPhone using Tapatalk
 
Yup it sure looks bent, simple solution is to replace it. Its not a numbered part. Regards Dave

Okay cool, I’ll go ahead and order one. I’ll toss the original in a bag for safe keeping.

I’ll try to straighten it too, very carefully. I have the proper tools, a nice nylon and brass tap it hammer.
 

Military Rifle Journal
Back
Top