Hi folks,
Finally found a byf44 in good enough shape to use for a high turret sniper clone.
Has anyone any information or tips on properly installing a set of turrets?
I want this to be a good representation but mainly a shooter. By no means am I ever going to even attempt to pass it off as real which is why i opted for split rings and not the solid, solder on type.
This is a sniper I am adding to my collection of sniper clones.
Many of you have probably seen my Isreali SSR I completed a few years back on other sites. (Gunboards, canadian gunnutz)
Ive since added an M1D clone built on a winchester receiver, all wra parts with genuine barrel block, cheek pad and t37 with lyman alaskan.
And No4T restoration. (Genuine 1943 no.4T, restored no32.mk1 scope, genuine pads and bracket, Not quite complete but close! Restoration thread on milsurps.com enfield knowledge library )
Any assistance will be greatly appreciated!
Jon
Finally found a byf44 in good enough shape to use for a high turret sniper clone.
Has anyone any information or tips on properly installing a set of turrets?
I want this to be a good representation but mainly a shooter. By no means am I ever going to even attempt to pass it off as real which is why i opted for split rings and not the solid, solder on type.
This is a sniper I am adding to my collection of sniper clones.
Many of you have probably seen my Isreali SSR I completed a few years back on other sites. (Gunboards, canadian gunnutz)
Ive since added an M1D clone built on a winchester receiver, all wra parts with genuine barrel block, cheek pad and t37 with lyman alaskan.
And No4T restoration. (Genuine 1943 no.4T, restored no32.mk1 scope, genuine pads and bracket, Not quite complete but close! Restoration thread on milsurps.com enfield knowledge library )
Any assistance will be greatly appreciated!
Jon
Last edited: