Roger S

You know these comments are interesting, I got the Rough Forged set to get educated on before I got my first G43. which I believe was...

The numbered parts would be the bolt carrier bolt firing pin housing and lugs as well as the stock. Also gas cylinder on these. BCD has...

Here is an exceptionally nice K43 panel cut that I picked up at SOS this year. This rifle has been posted here before but about 7 to 8...

They did not make many. Way cool! Is it clear?

Haven’t been fortunate enough to try it in a G43, but I’ve run Varget in my MAS 44, FN49, and Garand. Burn rate is super close to 4064...

Thanks for the info! I like 4350 for an alternative in K98s but know it is too slow for semiautos. Never tried many others and never...

Per Hodgen the starting load for 8mm Mauser with varget at 175 grains is 43.0, max is 50.5 max 150 is 45.5 starting, 52.4 max 200 is...

Been having troubles finding my go to powder IMR4064. I have loaded with IMR4895 which you can find but better results with 4064. Seems...

Putting a shooters kit on a G/K43 kit will protect an original stock that is not already experiencing stress cracks. I am also one that...

I agree the originals hold up well in large. For range day as is I would still swap the hand guard with a reproduction because I was...

Putting one of my shooters in a reproduction stock to preserve the original. This is from Murray's custom gun stocks. It turned out...

I have one on the way from Frontline just now. Got one from them before and it worked fine.

Without the latch you need to pull the carrier back to the mark on the stock and it should drop right in place. The safety needs to be on.

Very cool! Which makers codes do you have there if I may ask? It is always fun to line them up like that.

Very nice L block... One thing of note. You can always tell an orig. for what ever reason this is the only block where BLM used a...