Dialytan BMJ

L

lukasbouma

Member
Je to originál ww2 dialytan 4x bmj?
 

Attachments

  • IMG_3876.jpeg
    IMG_3876.jpeg
    223.9 KB · Views: 53
  • IMG_3875.jpeg
    IMG_3875.jpeg
    208.8 KB · Views: 52
  • IMG_3879.jpeg
    IMG_3879.jpeg
    195.8 KB · Views: 53
  • IMG_3874.jpeg
    IMG_3874.jpeg
    180.4 KB · Views: 54
  • IMG_3878.jpeg
    IMG_3878.jpeg
    223.4 KB · Views: 47
  • IMG_3884.jpeg
    IMG_3884.jpeg
    166.6 KB · Views: 46
  • IMG_3885.jpeg
    IMG_3885.jpeg
    176 KB · Views: 46
  • IMG_3888.jpeg
    IMG_3888.jpeg
    245.6 KB · Views: 44
  • IMG_3887.jpeg
    IMG_3887.jpeg
    189.4 KB · Views: 40
  • IMG_3886.jpeg
    IMG_3886.jpeg
    128.2 KB · Views: 40
  • IMG_3889.jpeg
    IMG_3889.jpeg
    196.5 KB · Views: 36
  • IMG_3890.jpeg
    IMG_3890.jpeg
    167.9 KB · Views: 36
  • IMG_3883.jpeg
    IMG_3883.jpeg
    220 KB · Views: 43
  • IMG_3895.jpeg
    IMG_3895.jpeg
    189.8 KB · Views: 30
Last edited:
Nice example of a HT BMJ Scope . Hard scope to find in original condition were something has not been replaced . Generally its the Rear Rings Middle block and locking lever that are replaced because there missing .
 
Thanks and I have a question about the adjustment ring for the reticle because it is the opposite of the other dialytans I have found and I also have a question about the screw in front of the rear assembly, which is also not found on the others
 
lukasbouma said:
Thanks and I have a question about the adjustment ring for the reticle because it is the opposite of the other dialytans I have found and I also have a question about the screw in front of the rear assembly, which is also not found on the others
Click to expand...
The saddle with dial has likely been removed at some point and just installed incorrectly locking screw should be facing forward as for screw it is original some BMJ Scopes have this screw on the underside some are on top side like yours .
 
Dave Roberts said:
The saddle with dial has likely been removed at some point and just installed incorrectly locking screw should be facing forward as for screw it is original some BMJ Scopes have this screw on the underside some are on top side like yours .
Click to expand...
Thank you for information. Could you please advise me how to turn the saddle with dial?
 
Unscrew cap on top of dial. Remove screw underneath. Remove dial. Remove 2 screws under dial that hold saddle to tube. Saddle should lift off. Then reassemble.
 
Thank you very much for the answers. And the last question is about the screw that I noticed was missing, would anyone be willing to measure it and advise in what position it should be screwed in? It is the small screw in the picture that secures the larger one
 

Attachments

  • IMG_3889.jpeg
    IMG_3889.jpeg
    196.5 KB · Views: 18
You must log in or register to reply here.
Back
Top