JGA Sportmodell Upper Handgun Ferrule

[markthenav]

I recently acquired a nice German Training Rifle made by Anschutz. It appears that the upper handguard is missing a metal ferrule for under the rear sight. I was wondering if anyone has one they can sell or knows where to source one? I'm also interested in some 4MM band pins either original or repro for the barrel bands. Thanks for the help!

Mark

 

[oldwing]

I made a dozen or so a few years ago and have a couple left. They fit the DSM34 and 36. Maybe a photo of your action will verify.

 

[markthenav]

I made a dozen or so a few years ago and have a couple left. They fit the DSM34 and 36. Maybe a photo of your action will verify.

Here you go. Hope this helps. I've seen several that didn't have a ferrule. Some looked snug and others pretty sloppy. Not sure what was the norm for Anschutz.

Best,
Mark

 

[swjXE]

Here you go. Hope this helps. I've seen several that didn't have a ferrule. Some looked snug and others pretty sloppy. Not sure what was the norm for Anschutz.

Best,
Mark

It would have had the ferrule.

 

[oldwing]

Mark, I sent a pm

 

[Fal Grunt]

Mark,

I make reproduction band pins:

DSM Band Pin

Reproduction - New manufacture DSM Band Pin copying the original profile. Originals varied in length (some significantly). US Made from US material, heat treated, and hot salt blued. Generic Pin - this pin does not match the original but is a functional lower cost alternative. Original - An...

www.myersarms.com